Re: Translated Source Address Using Default Gateway Not Alternate Public IP

Steve,

 I tried the following and neither worked. As you know, I couldn't use the gateway of eth4 because I get this error, https://www.screencast.com/t/ElJXug4duhbS. Needless to say, neither worked and bytes received is still 0.  I am almost to a point where I am going to ask about upgrading my 204 to an SRX300. How easy is it to bring over my policies and configuration? Do you know how I can view my peak/max concurrent connections I have had on my 204? I just want to make sure the SRX300-JB will work with my configuration. I have 2 private subnets and 2 public IP subnets and I connect to two other Juniper SSG VPNs (small office). 

When I deleted this route below, I looked at the logs and for literally one second, bytes received showed up but then it went back to 0 right after. This is what showed up when I deleted the route above and there were no routes in Source Routing.