Complete bootup log after plugging into the power:
Juniper Networks SSG5 Boot Loader Version 1.3.2 (Checksum: A1EAB858)
Copyright (c) 1997-2006 Juniper Networks, Inc.
Total physical memory: 256MB
Test - Pass
Initialization - Done
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Loading default system image from on-board flash disk...
00%
99%
100%
Done! (size = 15,253,504 bytes)
Ignore image authentication!
Start loading...
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
..................................................
Done.
Juniper Networks, Inc
SSG5/SSG20 System Software
Copyright, 1997-2008
Version 6.2.0r19.0
Load Manufacture Information ... Done
Initialize FBTL 0........ Done
Load NVRAM Information ... (6.2.0)Done
Install module init vectors
Install modules (01148800,020a0198) ...
PPP IP-POOL initiated, 256 pools
Initializing DI 1.1.0-ns
w3g_cfg_init
System config (1390 bytes) loaded
Done.
Load System Configuration ...................................................................modem is not detected
..................................Disabled licensekey auto update
....
Unsupported command - set snmpv3 local-engine id "0162072008003836"
.........Done
system init done..
login: System change state to Active(1)
login:
When I plugged the network cable into lan port I could login through http but when I plugged out the power and started again:
Juniper Networks SSG5 Boot Loader Version 1.3.2 (Checksum: A1EAB858)
Copyright (c) 1997-2006 Juniper Networks, Inc.
Total physical memory: 256MB
Test - Pass
Initialization - Done
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Loading default system image from on-board flash disk...
00%
99%
100%
Done! (size = 15,253,504 bytes)
Ignore image authentication!
Start loading...
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
..................................................
Done.
Juniper Networks, Inc
SSG5/SSG20 System Software
Copyright, 1997-2008
Juniper Networks SSG5 Boot Loader Version 1.3.2 (Checksum: A1EAB858)
Copyright (c) 1997-2006 Juniper Networks, Inc.
Total physical memory: 256MB
Test - Pass
Initialization - Done
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Loading default system image from on-board flash disk...
00%
99%
100%
Done! (size = 15,253,504 bytes)
Ignore image authentication!
Start loading...
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
..................................................
Done.
Juniper Networks, Inc
SSG5/SSG20 System Software
Copyright, 1997-2008
Juniper Networks SSG5 Boot Loader Version 1.3.2 (Checksum: A1EAB858)
Copyright (c) 1997-2006 Juniper Networks, Inc.
Total physical memory: 256MB
Test - Pass
Initialization - Done
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Loading default system image from on-board flash disk...
00%
99%
and so on ...
Maybe after connecting network cable something happens - but it's strange.