HI,
For RG0, node0 will be the primary based on the priority and you might want to use 192.168.20.248 to access Node0. When you try to reach 192.168.20.248, is it that you end up logging into Node1? How did you confirm the same?
What is the source subnet from which you are trying to the reach the management interfaces. If it is an external subnet and using a backup router, please check out this article: https://kb.juniper.net/InfoCenter/index?page=content&id=KB31029
However, as per the above article, the access to fxp0 on primary fails which is a bit different.
Hope this helps.
Thanks,
Pradeep
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!
Juniper Business Use Only
For RG0, node0 will be the primary based on the priority and you might want to use 192.168.20.248 to access Node0. When you try to reach 192.168.20.248, is it that you end up logging into Node1? How did you confirm the same?
What is the source subnet from which you are trying to the reach the management interfaces. If it is an external subnet and using a backup router, please check out this article: https://kb.juniper.net/InfoCenter/index?page=content&id=KB31029
However, as per the above article, the access to fxp0 on primary fails which is a bit different.
Hope this helps.
Thanks,
Pradeep
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!
Juniper Business Use Only