Re: SA usage for many proxy-id

Hi Pablo,

Thank you for your heply! I Hope you ar doing great too!

I understood from the KB that I can, for the same VPN “test” do the command below for each pair of local and remote IP.

set vpn test proxy-id local-ip 10.1.1.0/24 remote-ip 20.1.1.0/24 any

But since there is 15 local IP to each of the 10 remote, when I try the “get sa” command, there will be 150 SA defined.

I was trying to understand if te previous way mentioned, using policy based VPN, will use less SA and permit NAT to my source IP.

I really appreciate your help!

Best regards,

Bruno