NSRP, two SSG350Ms, and unmanaged switches in the Untrust Zone
Hi Guys, I've implemented the attached toplogy as a temporary measure whilst we decide the future architecture of our changing environment - only upstream interfaces are shown. So far this works...
View ArticleRe: NSRP, two SSG350Ms, and unmanaged switches in the Untrust Zone
Hi Mark, The Active/Passive setup looks fine and is as per the concept of NSRP. Your statement that the failover works seemlessly actually confirms it too.Regarding few packets seen on the snoop of...
View ArticleRe: High cpu with small amounts of VPN traffic
This is a design limitation. As mentioned in the previous response - AES-256 encryption-decryption is handled on the CPU of ISGs rather than on the ASIC chips. The CPU on these platforms can get...
View Article1-Port T1/E1 Mini-Physical (SRX-MP-1T1E1-R) Interface Module supports...
AFAIK, the said card should support Channelized E1s however it is not mentioned clearly in the documentations. Can any confirm the said support?
View ArticleRe: Do you know how to configure PAT?
Hi Guys, can you please share configuration for NAT/PAT for MX-5t routers ? reply on : shirish2489@gmail.com
View ArticleSSG5 HOST DYNDNS IS ASSOCIATING THE PRIVATE IP
Hello Experts: Have an SSG5, I am currently connected to an Internet link of my ISP with dynamic IP at the ETH 0/0 interface and when checking in the interface list I see that it obtains a private IP...
View ArticleRe: SSG5 HOST DYNDNS IS ASSOCIATING THE PRIVATE IP
Good day, Are you following this KB? https://kb.juniper.net/InfoCenter/index?page=content&id=KB4582&cat=DNS&actp=LIST I am not sure if this applies, but it seems you can hardcode the...
View ArticleRe: SSG5 HOST DYNDNS IS ASSOCIATING THE PRIVATE IP
Unfortunately there is nothing the SSG can do to change its behavior. The SSG and client only knows the address that the ISP gave the SSG so that is all it can report to DynDNS. In this case your...
View ArticleRe: SSG5 HOST DYNDNS IS ASSOCIATING THE PRIVATE IP
I did exactly this without change in the IP, however I was clarified that the problem is on the side of the ISP I really appreciate the attention and response
View ArticleRe: SSG5 HOST DYNDNS IS ASSOCIATING THE PRIVATE IP
Thanks spulka, it's clear to me I will review this with my ISP
View ArticleRe: ISG2000 6.3.0r16b.0 firmware update to 6.3.0r26
Reviewing release noted will give you a good idea about enhancements, fixes etc., https://www.juniper.net/documentation/product/en_US/screenos
View ArticleSSG5 keeps dropping connection to Shaw modem
Little history have a lihts and water system connected to the juniper which is remotely controlled from another location. The issue is that the connection between the shaw modem and the juniper loses...
View Articleunable to access DVR through ssg5
We are trying to port a dvr through the system to access the cameras and cannot see them here is a copy og the config, hope you can show me where is issue is. the cameras are on port 3777 tcp 3778...
View ArticleRe: unable to access DVR through ssg5
Hi, I see the below from your update: "******the cameras are on port 3777 tcp 3778 udp and also use port 80 set service "cameras" protocol tcp src-port 37777-37780 dst-port 37777-37780set service...
View ArticleRe: SSG5 keeps dropping connection to Shaw modem
I'm having trouble seeing what hardware Shaw uses and the technology for the client handoff method. You mentioned this is a static ip address, how is the interface facing the Shaw ISP configured? When...
View ArticleRe: unable to access DVR through ssg5
I have tried, but I do not see the folders in objects on my ssg5 6.2.0r5.0 am I doing something wrong?
View ArticleRe: unable to access DVR through ssg5
If the menus are not visible try a different browser. These older versions start displaying incorrectly on newer browsers at times. or you can make the config change on the cli commands.
View ArticleRe: unable to access DVR through ssg5
tried 4 different browsers still no other options under options is there a guide to using cli to accomplish this task? thanks michael
View ArticleRoute traffic through VPN tunnel
Hello, Before starting, I need to mention that I have never configured an firewall before and am therefore missing a lot of theory on this topic. I was given the task to configure an SSG-5 for an VPN...
View Article
